working through an MR26A, TM751, W800, etc. This depends on you receiving X-10 commands into HomeSeer in some way usually that's a PalmPad, keychain remote, sticky-switch, motion sensor, etc. Maybe someday I'll write an actual script to do that it would only be a few lines long. Limitations: This will work for on and off, but not quite for dim that requires a tiny bit more smarts, but more than will fit in a one-liner. For instance, to use a PalmPad set on housecode D to control Z-Wave (or indeed, any) devices on housecode R, make the event trigger be housecode D, and change the 'q' to 'r'. &hs.ExecX10 'q' & mid(hs.StringItem(hs.LastX10,2,' '),2), hs.StringItem(' on off dim',hs.StringItem(hs.LastX10,3,' '),' ')Д¬hange the q in the latter to whatever housecode you want to control. If the devices are on different housecodes: If the devices are on the same housecode: The action is a script command, as follows: For the unitcode, choose Any, and for the command, choose Any. Select the housecode that the X-10 devices are on. Solution: Create a single event in HomeSeer. Or, you have both X-10 and Z-Wave devices on the same devicecodes (or on the different housecodes but the same unitcodes), and you want to ensure that if you turn on the X-10 one from a PalmPad, the Z-Wave one comes on as well. Situation: You want to use an X-10 PalmPad and your existing X-10 interface on your HomeSeer system to control Z-Wave devices.

Homeseer z wave